Product Categories
Contact Us

Guangzhou Huangong Machinery Equipment Co.,Ltd

Add:D08-09 ZhuCun International Machinery Market GuangZhou City

Contact us:Jack





Excavator Bushing Work With Idle Speed

1. Oil, oil filter absolutely must use the factory pieces, Excavator Bushing according to the provisions of the maintenance cycle replacement. The old machine need to care more carefully, Excavator Bushing oil machine filter replacement time can be shortened as appropriate, so that the engine life longer.

2. Diesel oil as far as possible to use regular gas stations to provide, Excavator Bushing even if the regular gas stations add diesel, do not directly add fuel tanks, before adding filter (more commonly used method is in the refueling mouth set socks).

3. Drain water at the bottom of diesel oil and oil-water separator before commencement of daily. Diesel filter to buy the factory pieces, according to the maintenance cycle to replace the diesel filter. Clarify a point, the factory filter paper filter, impurity interception of large, so easy to plug, Excavator Bushing than the auxiliary filter replacement cycle short, so is not a long-term plugging cartridge is a good filter.

4. The air filter is often checked, Excavator Bushing the outer filter is used to blow the air from the inside out, the pressure cannot be too big to prevent the filter from blowing. Internal filtration cannot be cleaned in a blown manner. The external filtration clean 2, 3 times and the internal filtration and replace the new.

5. It is not necessary to use idle work for fuel saving to prevent carbon deposition.

6. Every day to check the water tank pump, Excavator Bushing to prevent water leakage phenomenon, so as not to cause the engine high temperature or flush cylinder.

1. According to the maintenance cycle to replace hydraulic oil, Excavator Bushing oil filter, pilot filter, and note that there is no adsorption of iron filings, copper crumbs. When using crusher, the deterioration of hydraulic oil is accelerated and the replacement period should be shortened.

2. Not long-term oil shortage work. After the replacement of hydraulic oil or hydraulic components, pay attention to air discharge. Pay attention to waterproof, do not involve deep water operations, Excavator Bushing do not use water directly to wash the electrical components when cleaning.

3. Rotary reducer, walking reducer to replace gear oil cycle.

4. The pin shaft part of the attention to clear dirt, Excavator Bushing add butter. Check the pin shaft bolts every day for loosening, shedding, missing, and fastening in time.

5. Check the structure of the daily cracks, deformation. Park the excavator to pay attention to the surrounding environment, parked in a solid and smooth hard ground, do not stop at the river Edge, Cliff edge, Excavator Bushing under the hillside, to prevent accidental danger.

6. When the bucket tank is fully retracted, the bucket falls to the ground to prevent the oil cylinder from being hit.

Hydraulic oil in the hydraulic system also plays a role in the lubrication of various components, Excavator Bushing if not replaced for a long time, the hydraulic oil black, hydraulic oil viscosity reduction, will directly lead to the excavator main pump injection, valve, multi-way reversing Valve,Excavator Bushing oil seals and other hydraulic system parts of the abnormal wear and tear, long time caused by the gap between the parts of the leakage and serious impact of the excavator movement continuity, powerless and so on.

1. The most likely to be the high-speed rotation of the pump to produce debris, Excavator Bushing about and pump rotation of all parts you have to take into account, such as bearings, volume chamber, such as wear;

2. Hydraulic valve spool back and forth operation, Excavator Bushing oil cylinder back and forth the grinding debris, but this short time will not occur this phenomenon;

3. Because it is a new machine, in the equipment will produce a lot of iron filings, Excavator Bushing I do not know if you change the oil tank when the hydraulic oil all empty, with the new oil circulation circulatory system, the tank all with cotton cloth wiped clean and then add new oil, Excavator Bushing if not, there may be a large number of scrap iron residue in the tank, will lead to new oil pollution and blackening;